Smeg CIR60X Uživatelský manuál

Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNECTION____

Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on

Instructions for the installer 13 5. GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and

Instructions for the installer 14 5.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions of

Instructions for the installer 15 6. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appl

Instructions for the installer 16 6.2 Regulation for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle C

Instructions for the installer 17 6.3 Regulation for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the u

Instructions for the installer 18 7.3 Arrangement of burners on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 7.4 Lubrifi

Instructions for the user 19 8. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted

Instructions for the user 20 8.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed, ev

Instructions for the user 21 8.4.2 Using the electric elements The electric elements are ideal for ultrarapid cooking. The settings shown in the t

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY

Instructions for the user 22 9. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 9.1 Cleaning C

Instructions for the user 23 9.2.1 Ignition plugs and safety devices For good functioning of the lighting ignition plugs and the safety devices, k

Instructions for the user 24 10. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should be

914772609/ B

Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASI

Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas appliances are installed by authorised persons. Clearance arou

Instructions for the installer 7 In case of installation on a hollow compartment with doors, a separating panel has to be placed under the hob.

Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances –

Instructions for the installer 9 be protected in accordance with Clause 5.12.1.2 to a height C of not less than 150 mm above the hob for the full d

Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in ac

Instructions for the installer 11 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page