Smeg A1AU6 Uživatelský manuál Strana 14

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 15
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 13
Instructions for the Installer
16
6. GAS SUPPLY REQUIREMENTS
WARNING
EXPLOSION HAZARD
- Use a new AGA or CSA-approved gas supply line.
- Install a shut-off valve.
- Securely tighten all gas connections.
- lf connected to LP, have a qualified technician ensure that the gas
pressure does not exceed a 14" water column.
- Examples of qualified technicians include licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
- Failure to do so can result in death, explosion, or fire.
NOTE:
- Observe all governing codes and ordinances.
- The cooktop must be connected to a regular gas supply.
1)
This installation must conform to local codes and ordinances. In the absence of local codes, installations
must conform to American National Standards, National Fuel Gas Code ANSI Z223.1 - latest edition** or
CANI 13149.1 or 2**.
2)
If local codes permit, a flexible metal appliance connector with the new AGA or CSA certified design, 4-5
feet (1.2-1.5 m) long, 1/2" or 3/4" I.D., is recommended for connecting this range to the gas supply line.
Do not bend or damage the flexible connector when moving the range. The pressure regulator has 3/8"
female pipe threads. You will need to determine the fittings required, depending on the size of your gas
supply line, the flexible metal connector and the shut-off valve.
3)
Always use pipe-joint compound made for use with NATURAL
GAS and L.P. GAS between pressure regulator D and NPT
adaptator C and between pressure regulator D and pipe E. If a
flexible metal conductor is used, make sure that the tubing is not
kinked.
Use only pipes (E) conforming to standard regulations in force,
inserting gasket B (supplied) between fitting A adaptator C.
Always place a suitable sealing medium (such as Teflon tape)
between pressure regulator D and adaptator C and between
pressure regulator D and pipe E.
WARNING: The tightening torque of adaptor (C )must not be greater than 36 ozf - 10 Nm.
Zobrazit stránku 13
1 2 ... 9 10 11 12 13 14 15

Komentáře k této Příručce

Žádné komentáře