Smeg SE290X-6 Manuál s instrukcemi stáhnout pdf (Strana 5)

Instructions for the Installer

2.2 Positioning the oven

The appliance is designed for building-in to cabinets made from any heat-

resistant material. Comply with the dimensions shown in figures 1, 2, and 3.

When installing under worktops, comply with the dimensions shown in figure

1-3.

When installing under worktops incorporating combined hobs, a gap of at

least 110 mm must be left from any side wall, as shown in figure 1.

When installing in tall units, comply with the dimensions shown in figure 1-2,

bearing in mind that the top/rear of the unit must have an opening 80-90 mm

deep.

Screw the 4 screws A into the inside of the frame (fig. 1).

For installation under tops, make sure that the rear/bottom of the unit has an

opening similar to that shown in figure 1 (ref. B). See the instructions supplied

with the hob for the relative positioning and fixing procedures.

1 2 3 4 5 6 7 8 9 10 ... 24 25

Žádné komentáře

Smeg SE290X-6 Manuál s instrukcemi Strana 5