Smeg FP850APZ Uživatelský manuál stáhnout pdf (Strana 23)

Instructions for the Installer

13.2 Positioning the oven

The appliance is designed for building-in to cabinets made from any heat-resistant material. Comply with

the dimensions shown in figures 1, 2, and 3. When installing under worktops, comply with the

dimensions shown in figure 1-3. When installing under worktops incorporating combined hobs, a gap of

at least 110 mm must be left from any side wall, as shown in figure 1. When installing in tall units, comply

with the dimensions shown in figure 1-2, bearing in mind that the top/rear of the unit must have an

opening 80-90 mm deep. Screw the 4 screws A into the inside of the frame (fig. 1). For installation under

counter-top hobs, make sure that the rear/bottom of the unit has an opening similar to that shown in

figure 1 (ref. B). See the instructions supplied with the hob for the relative positioning and fixing

procedures.

Never use the door for leverage when inserting the oven in the cabinet. Never

apply excessive pressure to the open door.

1 2 ... 18 19 20 21 22 23

Žádné komentáře

Smeg FP850APZ Uživatelský manuál Strana 23